Krell Industries DVD Standard Manuel d'utilisateur télécharger pdf (Page 9)

Krell DVD Standard 5

Before you install the DVD Standard into your system, review the

following guidelines to choose the location for the component. This

will facilitate a clean, trouble-free installation. The DVD Standard

does not require any type of special rack or cabinet for installation.

Place the DVD Standard on a firm, level surface, away from exces-

sive heat, humidity, or moisture. The DVD Standard requires at least

two inches (5 cm) of clearance on each side and at least two inches

(5 cm) of clearance above and below the component to provide ade-

quate ventilation. Installations inside cabinetry may need extra venti-

lation.

The DVD Standard has superb regulation and does not require a

dedicated AC circuit. Operate the DVD Standard only with the power

cord supplied.

Avoid connections through extension cords or multiple AC adapters.

High quality 15 amp grounded AC strips are acceptable. High quality

AC line conditioners or filters may be used if they are grounded and

meet or exceed the unit’s power supply rating of 100 VA.

Please contact your Krell dealer, distributor, or Krell before using any

device designed to alter or stabilize the AC power for the DVD

Standard.

Placement

The DVD Standard incorporates an advanced suspension system and does

not require additional mass coupling or isolation. You may experiment with

feet or cones as long as they are not permanently affixed to the unit. Any

unauthorized modifications to the unit or electronics will void the warranty.

Do not attach enhancement accessories such as rings, mats, or

dampers to individual discs. These accessories may interfere with the

disc transport, resulting in erratic playback and/or poor performance.

Note

IMPORTANT

AC Power

Guidelines

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

Pas de commentaire

Krell Industries DVD Standard Manuel d'utilisateur Page 9